Título

Polymer-cement mortar with quarry waste as sand replacement

Autor

DANIEL NAPOLEON GOMEZ BALBUENA

T. LOPEZ-LARA

Juan Bosco Hernandez - Zaragoza

REBECA GUADALUPE ORTIZ MENA

MARIA GUADALUPE NAVARRO ROJERO

jaime horta rangel

RENE SALGADO DELGADO

VICTOR MANUEL CASTAÑO MENESES

Nivel de Acceso

Acceso Abierto

Referencia de publicación

doi: 10.1155/2018/3984835

URL/https://www.hindawi.com/journals/amse/2018/3984835/

ISSN/1687-8442

Resumen o descripción

The activities of carved Quarry extraction generate problems of landscape pollution such is the case of solid waste discharged into open land dumps in central Mexico. This article presents the technological application of this solid waste in a new polymeric material with properties similar to those of a traditional mortar. It is concluded that the polymeric material uses low amounts of cement with respect to the traditional mortar, and it is elaborated with the recycled quarry as they are presented in its granulometry. The polymer used favored a low water/cement ratio (0.3) which did not allow to decrease resistance due to the fine nature of the materials (residues and cement) in addition to maintaining the workability of the material. The quarry residue was classified as silt with low plasticity and was characterized by X-ray diffraction and Fluorescence to identify 76% of SiO2, which is why it was used as a stone aggregate even though the fines content was approximately 93%. The maximum compression resistance obtained at 28 days were 8 Mpa with the polymer/solid ratios of 0.10, water/solids of 0.30, and quarry/solids of 0.67. Linear equations were analyzed for more representative values with R squared adjustment.

Editor

Hindawi

Fecha de publicación

2018

Tipo de publicación

Artículo

Versión de la publicación

Versión publicada

Formato

application/pdf

Fuente

Advances in Materials Science and Engineering, vol. 2018, Article ID 3984835

Idioma

Inglés

Audiencia

Público en general

Sugerencia de citación

D. N. Gómez-Balbuena, T. López-Lara, J. B. Hernandez-Zaragoza, et al., “Polymer-Cement Mortar with Quarry Waste as Sand Replacement,” Advances in Materials Science and Engineering, vol. 2018, Article ID 3984835, 10 pages, 2018. doi:10.1155/2018/3984835

Repositorio Orígen

CIATEQ Digital

Descargas

697

Comentarios



Necesitas iniciar sesión o registrarte para comentar.