Título
AA2024–CNTs composites by milling process after T6-temper condition
Autor
ROBERTO MARTINEZ SANCHEZ
RAUL PEREZ BUSTAMANTE
IVANOVICH ESTRADA GUEL
JOSE MARTIN HERRERA RAMIREZ
MARIO MIKI YOSHIDA
Nivel de Acceso
Acceso Abierto
Referencia de datos
doi: http://dx.doi.org/10.1016/j.jallcom.2011.12.001
Materias
Resumen o descripción
The 2024 aluminum alloy produced from elemental powders and reinforced by the addition of carbon nanotubes were microstructural and mechanically characterized. Composites were synthesized through milling process followed by cold consolidation, sintering and hot extrusion. The effect of the nanotubes on the microstructure and mechanical properties were analyzed in the composites after T6 thermal treatment. Al4C3 formation was due to the reaction of carbon nanotubes and Al matrix. Precipitated Al–Cu phase coexists and presents interaction with crystallized carbide and dispersed nanotubes. There is a direct relationship of carbon nanotubes content and hardness answer.
Fecha de publicación
25 de septiembre de 2012
Tipo de publicación
Artículo
Recurso de información
Formato
application/vnd.openxmlformats-officedocument.wordprocessingml.document
Idioma
Inglés
Relación
&
Martínez-Sánchez, R. (2012). AA2024–CNTs composites by milling process after T6-temper condition. Journal of Alloys and Compounds, 536, S17-S20.
Sugerencia de citación
Pérez-Bustamante, R., González-Ibarra, M. J., González-Cantú, J., Estrada-Guel, I., Herrera-Ramírez, J. M., Miki-Yoshida, M.,
Repositorio Orígen
Fuente de Objetos Científicos Open Access
Descargas
322