Título

Characterization of Al2024-CNTs composites produced by mechanical alloying

Autor

RAUL PEREZ BUSTAMANTE

FERNANDO PEREZ BUSTAMANTE

IVANOVICH ESTRADA GUEL

CARLOS ROBERTO SANTILLAN RODRIGUEZ

JOSE ANDRES MATUTES AQUINO

JOSE MARTIN HERRERA RAMIREZ

MARIO MIKI YOSHIDA

Nivel de Acceso

Acceso Abierto

Licencia

http://creativecommons.org/about/cc0/

Materias

Carbon nanotubes - (ALUMINIUM COMPOSITES) Mechanical alloying - (MICROSTRUCTURE) CIENCIAS FÍSICO MATEMÁTICAS Y CIENCIAS DE LA TIERRA - (CTI) FÍSICA - (CTI) OTRAS ESPECIALIDADES FÍSICAS - (CTI) OTRAS - (CTI)

Resumen o descripción

In the present work, the 2024 aluminum alloy (Al2024) alloy has been produced by mechanical alloying (MA). The alloy was then strengthened by dispersion of carbon nanotubes (CNTs) during different times. Thus, the effect of CNTs concentration and milling time on the microstructure of the Al2024-CNTs composites was studied. The results show a homogeneous dispersion of CNTs into the Al-matrix phase by mechanical milling (MM). It was observed that the increment in the milling time, for a fixed amount of CNTs, causes a reduction of the particle size of powders resulting from MA. The finest particle size was obtained at 20 h of milling. These observations were confirmed by scanning and transmission electron microscopy. After 10 h of milling, Cu, Mg and other alloying elements constituting the Al2024 alloy, form a solid solution and only some remnant Mn particles were observed but not detected by X-ray diffraction.

Fecha de publicación

2011

Tipo de publicación

Memoria de congreso

Versión de la publicación

Versión enviada

Recurso de información

http://cimav.repositorioinstitucional.mx/jspui/handle/1004/1832

Formato

application/pdf

Idioma

Inglés

Repositorio Orígen

Fuente de Objetos Científicos Open Access

Descargas

494