Búsqueda avanzada


Área de conocimiento




123 resultados, página 2 de 10

Electrocoagulation to remove silica from cooling towers water

IVAN EMMANUEL VILLEGAS MENDOZA ALEJANDRA MARTIN DOMINGUEZ SARA PEREZ CASTREJON Silvia Gelover Santiago (2014, [Artículo])

El presente artículo muestra los resultados de un estudio que se llevó a cabo para evaluar el efecto de la calidad del agua en la remoción de sílice disuelto mediante un proceso de electrocoagulación utilizando electrodos de aluminio. La sílice se encuentra en el agua de repuesto (RW) y de purga de las torres de enfriamiento (CTBW). Las pruebas se hicieron a escala semipiloto a flujo continuo en un tren de tratamiento consistente de electrocoagulación (EC), floculación, sedimentación y filtración en arena. Se estudiaron dos RW y CTBW, con características fisicoquímicas diferentes. Las variables de respuesta analizadas fueron las siguientes: eficiencia del aluminio para remover sílice (relación mgl-1 de Al3+ dosificado/mgl-1 de sílice removido), eficiencia de remoción de Al3+ dosificado, pérdida de carga hidráulica a través del reactor electroquímico y el voltaje. Se calculó el costo del tratamiento de los cuatro tipos de agua. La relación mgl-1 de Al3+ dosificado/mgl-1 de sílice removido osciló de 1.09 ± 0.06 a 1.33 ± 0.05 al tratar RW, mientras que para CTBW fue de 0.85 ± 0.1. Los costos de energía, sustancias químicas y consumo de electrodos para el tratamiento de RW osciló de US$0.52 a US$ 0.74 m-3, y el costo del tratamiento de CTBW fue de aproximadamente US$0.53 m-3.

Aluminio Torre de enfriamiento Electrocoagulación Agua de repuesto Ciclos de concentración INGENIERÍA Y TECNOLOGÍA

Internal erosion under spillway rested on an embakment dam

JOSE RAUL FLORES BERRONES (2015, [Artículo])

This paper presents the investigation about the mechanism of internal erosion caused in the right abutment of the Shahghasem dam’s spillway. Shahghasem dam is an earthen dam located in Yasouj, in southwest of Iran. A significant hole and pipe have been observed in the corner of the right abutment from upstream view. The foundation is Marlstone, which has low cohesion and susceptible for internal erosion and piping in some conditions. Going through details of the design maps has shown that Lane’s criteria for selecting safe dimensions of the seepage control measures have not been considered properly. A series of the supportive walls are designed to attach to the right part of the spillway in order to increase the length of seepage. The pipe route of the erosion should also be grouted with high quality concrete.

Erosión del suelo Aliviaderos Presas Filtración INGENIERÍA Y TECNOLOGÍA

Usando la descomposición de un grafo Halin para el diseño de algoritmos autoestabilizantes

Using Halin graph decomposition for the design of self-stabilizing algorithm

Daniel Uriel Orozco Lomelí (2023, [Tesis de maestría])

Sea G = (V, E) un grafo no dirigido. El problema de encontrar un conjunto independiente fuerte en G, es identificar un conjunto S ⊆ V , tal que dados dos vértices arbitrarios de S, éstos estén separados entre sí por el menos tres aristas. Encontrar un conjunto S de tamaño máximo pertenece a la clase NP-Difícil. Por otro lado, el problema de encontrar un conjunto dominante total en G es identificar un conjunto D ⊆ V , tal que cualquier vértice en V tenga al menos un vecino que pertenezca a D. Encontrar un conjunto D de tamaño mínimo también pertenece a la clase NP-Difícil. En este trabajo de tesis se diseñaron dos algoritmos, uno que resuelve el problema de encontrar un conjunto independiente fuerte maximal y otro que resuelve el problema de encontrar un conjunto dominante total minimal. Estos dos problemas son menos restrictivos que las versiones de optimización descritas al principio de este texto y se sabe que pertenecen a la clase P. Los algoritmos diseñados corren en un sistema distribuido, son autoestabilizantes, son tolerantes a fallas transitorias y funcionan para grafos Halin. Los grafos Halin pertenecen a la clase de grafos 2-outerplanares y tienen la propiedad de que se pueden partir en dos subgrafos muy conocidos, un árbol y un ciclo. Los algoritmos propuestos aprovechan la propiedad anterior para disminuir la complejidad de los mismos. Hasta donde tenemos conocimiento, los algoritmos propuestos, que corren en tiempo lineal en el número de vértices, son los algoritmos más rápidos existentes para los problemas del conjunto independiente fuerte maximal y el conjunto dominante total minimal.

Let G = (V, E) be an undirected graph. The problem of finding a strong stable set in G, is to identify a set S ⊆ V , such that given two arbitrary vertices of S, they are separated from each other by at least three edges. Finding a set S of maximum size belongs to the class NP-Hard. On the other hand, the problem of finding a total dominanting set in G is to identify a set D ⊆ V , such that any vertex in V has at least one neighbor belonging to D. Finding a set D of minimum size also belongs to the class NP-Hard. In this thesis work, two algorithms were designed, one that solves the problem of finding a maximal strong stable set and one that solves the problem of finding a minimal total dominanting set. These two problems are less restrictive than the optimization versions described at the beginning of this text and are known to belong to the P class. The designed algorithms run on a distributed system, are self-stabilizing, are transient fault tolerant, and work for Halin graphs. Halin graphs belong to the 2-outerplanar class of graphs and have the property that they can be split into two well-known subgraphs, a tree and a cycle. The proposed algorithms take advantage of the above property to decrease the complexity of the algorithms. To the best of our knowledge, the proposed algorithms, which run in linear time in the number of vertices, are the fastest existing algorithms for the maximal strong stable set and minimal total dominating set problems.

Grafo Halin, Sistemas Distribuidos, Autoestabilización, Conjunto Independiente Fuerte, Conjunto Dominante Total Halin Graph, Distributed Systems, Self-stabilizing, Strong Stable Set, Total Dominating Set INGENIERÍA Y TECNOLOGÍA CIENCIAS TECNOLÓGICAS TECNOLOGÍA DE LOS ORDENADORES LENGUAJES ALGORÍTMICOS LENGUAJES ALGORÍTMICOS

El amaranto o huauhtli sagrado del México prehispánico y alimento de alto valor nutricional del México contemporáneo

JESUS ALFREDO ARAUJO LEON Ivonne Sánchez del Pino Víctor Aguilar Hernández SERGIO RUBEN PERAZA SANCHEZ ROLFFY RUBEN ORTIZ ANDRADE ANDRES XINGU LOPEZ Ligia Guadalupe Brito Argáez J. NAHIM ALCOCER ESPEJEL (2023, [Artículo])

El amaranto o huauhtli es uno de los alimentos más versátiles y nutritivos del continente americano. Los frailes españoles documentaron en sus crónicas del siglo XVI, la amplia variedad de platillos que los mexicas elaboraban con huauhtli. También destaca la importancia de las semillas de amaranto en las prácticas religiosas y su uso en la elaboración de imágenes sagradas (principalmente comestibles) para los dioses. El amaranto fue importante para la agricultura, la gastronomía y los rituales del México antiguo. El presente ensayo documenta la historia del amaranto en las ceremonias mexicas y su importancia como "súper alimento" en la actualidad

AMARANTHUS HYPOCHONDRIACUS ALEGRIAS SUPER ALIMENTO MEXICAS HERENCIA PREHISPANICA BIOLOGÍA Y QUÍMICA CIENCIAS DE LA VIDA BIOLOGÍA VEGETAL (BOTÁNICA) ECOLOGÍA VEGETAL ECOLOGÍA VEGETAL

Estimating lime requirements for tropical soils: Model comparison and development

Fernando Aramburu Merlos João Vasco Silva Frédéric Baudron Robert Hijmans (2023, [Artículo])

Acid tropical soils may become more productive when treated with agricultural lime, but optimal lime rates have yet to be determined in many tropical regions. In these regions, lime rates can be estimated with lime requirement models based on widely available soil data. We reviewed seven of these models and introduced a new model (LiTAS). We evaluated the models’ ability to predict the amount of lime needed to reach a target change in soil chemical properties with data from four soil incubation studies covering 31 soil types. Two foundational models, one targeting acidity saturation and the other targeting base saturation, were more accurate than the five models that were derived from them, while the LiTAS model was the most accurate. The models were used to estimate lime requirements for 303 African soil samples. We found large differences in the estimated lime rates depending on the target soil chemical property of the model. Therefore, an important first step in formulating liming recommendations is to clearly identify the soil property of interest and the target value that needs to be reached. While the LiTAS model can be useful for strategic research, more information on acidity-related problems other than aluminum toxicity is needed to comprehensively assess the benefits of liming.

Exchangeable Acidity Aluminum Saturation Calcium Carbonate Equivalent CIENCIAS AGROPECUARIAS Y BIOTECNOLOGÍA CHEMICOPHYSICAL PROPERTIES LIMES TROPICAL ZONES ACID SOILS ALUMINIUM BASE SATURATION CALCIUM CARBONATE

Mejoramiento del grado de uso del nitrógeno en maíz mediante técnicas parcelarias de riego por superficie

Improving the usage level of nitrogen in maize, through surface irrigation plot techniques

JAIME MACIAS CERVANTES JESUS DEL ROSARIO RUELAS ISLAS PABLO PRECIADO RANGEL WALDO OJEDA BUSTAMANTE MARCO ANTONIO INZUNZA IBARRA JOSE ALFREDO SAMANIEGO GAXIOLA (2015, [Artículo])

El maíz es uno de los principales cultivos sembrados en el estado de Sinaloa; sin embargo, en esta región la aplicación de riegos se realiza sin considerar las características físicas del suelo incrementando las pérdidas de agua y fertilizantes. Es importante desarrollar tecnologías que permitan optimizar el uso de insumos (agua, fertilizantes, pesticidas) incrementando el potencial productivo de los cultivos y reduciendo los costos de producción, por tal motivo, se desarrollaron una serie de experimentos durante los ciclos otoño-invierno 2006-2007 y 2011-2012 en el norte de Sinaloa, México, con el propósito de conocer el efecto del riego por gravedad por diferentes técnicas en la eficiencia de uso del nitrógeno (N) en el cultivo de maíz.

Riego de baja presión Riego de superficie Nitrógeno Cultivos alimenticios Maíz INGENIERÍA Y TECNOLOGÍA